CIRCUIT BOARD PROTECTATION

FEATURES

A transparent protective film is formed on various printed circuit boards to prevent electric leakage and short circuit. It can prevent the erosion of weak acid, alkali, alcohol and moisture, as well as mold and salt fog. This product is resistant to high temperature and will not drip in case of heat. This product has waterproof, moisture-proof, dust-proof and improved insulation strength.



APPLICATION

Suitable for isolate the contact between circuit board, wire, cable, wire connector, switch box, etc. and the external environment; It is used for TV to prevent corona caused by leakage of components such as high-voltage package; It can also be used to prevent electronic equipment such as communication signal antenna transmitting device from being eroded by moisture and salt fog.



USAGE

1.Shake well before use about 5 to 10 seconds. 2.Spray at the required position about 20cm-30cm away from the object surface.



ATTENTION

1. Please keep it in a place where keep away from children and pets.

2. Please do not contact the eyes. Once contacted, please rinse with plenty of water and seek medical advice immediately.

3.Store in a cool, ventilated and dry place,take away from fire, and in a warehouse with a room temperature lower than 45 ℃, and do not put it upside down.

4.It shall not be close to heat source, acid-base, oxidant and other corrosive substances, and shall not be exposed to the sun.

5. Do not store with food and other chemicals, if accidentally eated, please seek medical advice.